Instruction Manual

and then click on the Modify button to save your

changes.The table row is updated accordingly.

Note that depending on the current selection on this

page, the button located underneath the three fields

on the left may be either grayed or with a different

label (Add or Modify).

– Deleting a message definition can be done by simply

clicking on the corresponding “trash” sign in the Clear

column on the far right. This deletes the table row.

– There is also a Clear All button under the table that

allows you to delete all message definitions from the

table in one click.

• Click on the Configure button to save all the changes made

and then go back to the Base Setup menu

• Use one of the typical applications described below to

make the generated data available to users:

– Radio transmitter

– Direct IP via modem

– Direct IP via Ethernet

– NTRIP server via modem

– NTRIP server via Ethernet

– RTK corrections delivered on port A, B or F

– Ethernet data streaming.

Radio Transmitter

• Click on Base Setup > Transmitter and define the general

parameters of the base, as explained in section General

ProFlex 800

RTK Corrections

Serial Port

ProFlex 800

RTK Corrections

Radio

UHF Connector

External Radio

(Internal)