Instruction Manual

• Still on the Base Setup page, make sure the Connection

fields in the Serial Port x panes are all set to “None/Cable”

•In the Network x pane, choose “Ethernet Direct IP - Port P”

in the Connection field.

• Because the base is necessarily a client, enter the

information (Connect Now, Address, Port) allowing it to

connect to the rover (the server) to which it is supposed to

deliver its corrections. No Login or Password is needed in

this case.

Enable Connect Now to allow the receiver to establish the

connection right after you have clicked on Configure.

• In the corresponding Differential Stream x pane, choose

Port= “P - Ethernet” as the output port delivering the

generated differential data. In the Message field, choose

the type of differential message provided through this port

(ATOM, RTCM, CMR, CMR+ or DBEN).

NOTE: The receiver has been designed to offer two

separate and independent differential data outputs. Each

one can output a specific type of differential message. If

only one output is used, select Port=“None” for the other

output.

• Click on the Configure button to let the Web Server load all

your new parameters to the receiver. You have now

reached the end of the configuration phase.

NTRIP Server Via

Modem

CAREFUL: In the RTCM sense, an “NTRIP server” is a source

of corrections feeding an NTRIP caster (see RTCM paper

200-2004/SC104-ST). But from the point of view of the

network terminology, an “NTRIP server” is a client, not a

server.

The internal modem should be configured first:

• Click on the Connections menu and then on the Bluetooth/

Modem sub-menu.

Modem

ProFlex 800

(Mobile Wireless

Communication)

Internet

(Client)

IP address

or server name

NTRIP Caster

Users