Product Manual

Regulatory Information

U.S.A.

This device complies with Part 15 of the FCC Rules. Operation is subject to

the following two conditions: (1) this device may not cause harmful

interference, and (2) this device must accept any interference received,

including interference that may cause undesired operation.

This equipment has been tested and found to comply with the limits for a Class

B digital device, pursuant to Part 15 of the FCC Rules. These limits are

designed to provide reasonable protection against harmful interference in a

residential installation. This equipment generates, uses and can radiate radio

frequency energy and, if not installed and used in accordance with the

instructions, may cause harmful interference to radio communications.

However, there is no guarantee that interference will not occur in a particular

installation. If this equipment does cause harmful interference to radio or

television reception, which can be determined by turning the equipment off

and on, the user is encouraged to try to correct the interference by one or more

of the following measures:

- Reorient or relocate the receiving antenna.

- Increase the separation between the equipment and receiver.

- Connect the equipment to an outlet on a circuit different from that to

which the receiver is connected.

- Consult the dealer or an experienced radio/TV technician for help.

Canada

This digital apparatus does not exceed the Class B limits for radio noise

emissions from digital apparatus as set out in the radio interference regulations

of the Canadian Department of Communications. Le présent appareil

numérique n’émet pas de bruits radioélectriques dépassant les limites

applicables aux appareils numériques de Classe B prescrites dans le règlement

sur le brouillage radioélectrique édicté par le Ministère des Communications

du Canada.

Korea

For users in Korea the power supply must have the “ek” mark (a Korean safety

requirement) and can be purchased separately.

The ratings are: 5 Volts, 4 Amps.

Connector - Center positive standard 2.5 mm DC power connector.