Reference Manual User Manual

GPS Reference Manual
38
Interval
: is where you enter the interval criteria used for continuous
collection modes. The
Interval
field is not available if either of the
manual methods is selected.
Update Rate
: is where you set the receiver to
One Hz
or
Five Hz
mode.
When
Five Hz
is selected, the receiver will compute positions five
times a second so the display will update in near real time and
measurement latency will be minimized.
: opens the Occupy Data Points
screen (Page R-39), where data
can be collected.
Offset Shots
The Offset Shots screen is used to collect a point you cannot
physically occupy with GPS. You can occupy a nearby point and then
specify an offset to the point stored, or take a shot to it using a laser
range finder.
Offset Point
: is the point name of the offset point to be
stored.
Description
: is the description of the offset point to be
stored.
/ : is the direction or bearing from
the occupied point to the offset point.
: is used to compute the
azimuth or bearing from the reference point to the offset
point by occupying a second reference point on line with
the offset point. Once tapped, a prompt opens for the
name to store the reference point followed by the Occupy
Data Points screen (Page R-39). After measuring the
coordinate at the occupied point, you will return to the
Offset Shots
screen where you will be prompted to pick
the direction to the offset point.
/ : is where you enter the zenith angle or
vertical distance from the occupied point to the offset point.
Slope Dist
/
Horizontal Dist
: is where you enter the slope distance or
horizontal distance from the occupied point to the offset point.