Reference Manual User Manual

GPS Reference Manual
82
Note: When
Store GPS Raw Data
on the Job/ Settings/ Measure Mode
card (Page R-8) is set to
+ Rx. Raw (
and / or
+OBN
for
Ashtech)
switching from
ROVING
to
OCCUPYING
will start a session in the
receiver, so you will be prompted for a point name and description.
The receiver session will be completed and the measurement stored
when you tap . The occupation is not stored in the Survey Pro
.RAW file if you toggle back to
ROVING.
: allows you to store a side shot measurement during stake
out. This button opens a prompt for the side shot point name and
launches the GPS Occupy Data Points
screen. After you store the
new point (or cancel) you will resume with the GPS Staking
screen.
: opens the third and final Stake Points
screen where the
current stake point can be staked and optionally stored.
Stake to Line
The Stake to Line screen allows you to locate points on a continuous
predefined line. Direction information is provided to locate the line
by traveling the shortest possible distance (a perpendicular offset to
the line) between the rover and the line.
The first screen of this routine is similar to the conventional method,
except that the button is replaced with a button
to configure rover antenna and the backsight information is replaced
with rover antenna height information. See the conventional
Reference Manual for details.