User Manual Owner's manual

GPS Module
239
Start GPS Survey – Connect to
Receiver
Before the Base Setup, Rover Setup, or Data Collection screens are
opened, you will be prompted to connect to the appropriate receiver.
The Connect to Receiver
screen is used to display a list of all of the
receivers of the appropriate type (base, rover,
or post processing) you can connect to. If you
have used this type of equipment with this
data collector before, then the receiver you last
used is remembered and you can proceed
simply by tapping Enter or Connect>. If you
need to create a new receiver or change the
receiver settings, you can tap Create New
Receiver to open the Receiver Setup screen, or
tap Receiver Settings to open the Job > Settings
> Receiver screen.
Start GPS Survey – Base Setup
The Base Setup wizard is used to setup an RTK base receiver, and to
configure the base reference position in Survey Pro.
Base Setup One – Pick Point
The first step of the Base Setup wizard is to
pick a point for the base reference position, and
measure the antenna height at the setup.
1. Set the base receiver antenna over the
point.
2. Tap Setup HR to select your antenna type
and measure the slant or vertical height of
the antenna.
3. Enter a name for the Base Point. You can
select an existing point from the job or you
can enter a new point name for the job. If