Reference Manual User guide

Survey Pro Reference Manual
R-46
screen are used in determining when two shots are at the same
location.
; Survey with True Azimuths: automates the process of adjusting
the circle on the total station when traversing so that you can survey
with azimuths rather than horizontal angles (see Page R-133).
Scale Factor: displa
ys the details on the current mapping plane scale
factor, if one is configured.
Setup Scale… : access the Scale Settings screen where a mapping
plane scale factor can be configured in a variety of ways, or disabled.
Scale Settings
Job Settings Surveying Setup Scale.
The Scale Settings screen is the starting point for setting up a
mapping grid scale factor. Once configured, you will return to the
Surveying Settings
screen where you must then tap to save the
scale settings.
Do not use a scale factor: This option will disable any
mapping plane scaling that is currently enabled.
Use a single combined scale factor: This uses a single
combined scale factor that is provided for you, or one can
be computed with the Calculate Scale
wizard.
Use a grid factor with sea level correction: This
option uses a mapping plane scale factor that is adjusted
for elevation changes.
Use automatic map plane grid factor with sea level
correction: This option uses a combined scale factor that
is adjusted for elevation changes.
Use map plane ground coordinates: When checked,
you can configure the job to use map plane ground
coordinates.
Combined Factor: is where you enter a combined scale factor if
already known, otherwise it is the combined scale factor computed
from the Calculate Scale
wizard.