User Manual

51
Independently for each type, you can set the following criteria:
– Solution quality: “Fixed only” or “Code, Float or Fixed”
– Max. tolerated HRMS and VRMS values
– Max. tolerated PDOP value
– Minimum number of satellites required (Min SV).
– Minimum position averaging time, in seconds (Average for)
– Automatically accept data collection or not when criteria are met.
NOTE: The last two criteria make sense when the receiver is set to static to give
the best averaged position. Since in Topo SS point collection Survey Pro is
allowed to store a point using the single latest epoch of data, these two criteria
are irrelevant in that case (compare the two screen examples on the left).
If you enabled raw data logging for post processing, the Post Process tab is
also accessible through which you will set the RTK autonomous points field
as follows:
– Allow in PPK Survey: Choose this option to allow Survey Pro to store an
autonomous solution for a data point. This will happen during an RTK
survey in case of intermittent or prolonged data link failure. By doing
this, you will be able, after the survey and through post-processing, to
calculate a precise solution for the point using the data from the GNSS
raw data file (PPK logging file).
– Do Not Store: No autonomous point will be stored.
• Tap to save your settings. Survey Pro displays the Data Collection screen.
Collecting Data Standard data collection routines are presented below. Keep in mind that you
may have to solve the calibration before your measured GNSS coordinates are
properly transformed into your local grid (see Solving Calibration on page 57).
Remember also that you can access the data collection functions from the
active map after you have tapped and held on the map and selected Survey
Mode from the popup menu.