Installation Guide

Table Of Contents

Remove the Shipping Bracket Ensure ESD Protection

December 2022 Shipping Bracket Installation & Removal — Spectra Stack Library

4. Usinga#1Phillipsscrewdriver,removethetwoscrewsthatsecurethe

shippingbrackettothechassis(

2)andinstallthescrewsunderthe

handleoftheroboticshippingbracket(

1).

5. Usingyourfinger,holdtheroboticelevatorinplace(seeFigure6on

page8

)whileyoupulltheshippingbracketoutofthechassis.

6. Releasetheelevatorandallowittoslowlydescendtothebottomofthe

chassis.

7. Storethebracketandscrewsforuseifyouneedtomovethelibrary

afterinstallation.

8. Usinga#1Phillipsscrewdriver,removethetwoscrewsthatsecurethe

slot1drivebaycover.

9. Movethedrivebaycovertotheslot5positioninthelibrary.

10. Usinga#1Phillipsscrewdriver,installthetwoscrewsyouremovedin

Step8tosecurethecovertothechassis.

Figure 14 The robotics shipping bracket rear panel.

Figure 15 The rear of the Spectra Stack chassis.