Installation Guide

4
ROBOTICS SHIPPING BRACKET
INSTALLATION & REMOVAL
Thisdocumentdescribesinstallingandremovingtheroboticsshipping
bracketinaSpectraStacklibrary.Thebracketisonlyrequiredwhena
Stacklibraryisinstalledinadatacenterrackpriortoshipping.
Estimated Time = 5 - 10 minutes
BEFORE YOU BEGIN
Beforeinstallingorremovingtheshippingbracket,makesurethatyou
haveaddressedthefollowingrequirements.
Gather Materials and Tools
Required
 A#1Phillipsscrewdriver
 Asmallscrewdriver
Recommended
 Ananti‐staticmat
 Astaticprotectionwristbandorgroundingfootstrap
Ensure ESD Protection
Theinstallationenvironmentmustbefreeofconditionsthatcouldcause
electrostaticdischarge(ESD).ToprotecttheunitfromESD,followthese
procedureswhenrepairingortestingtheproduct:
 Placeastaticprotectionmatontheworksurfaceusedwhileremoving
andinstallingcomponents.Usea1‐megohmresistortogroundthe
staticprotectionmat.