SDS

Hazardous Material Identification
System-(HMIS)
HEALTH - 1
REACTIVITY - 0
Chemsico
Division of United Industries Corp.
P.O. Box 142642
St. Louis, MO 63114-0642
Material Safety Data Sheet
Complies with OSHA's Hazard Communication Standard, 29 CFR 1910.1200
FLAMMABILITY - 2 PERSONAL -
Rubber gloves
I Trade Name: Spectracide Pruning Seal
Product Type: Aerosol Tree Wound Dressing
EPA Registration Number Manufacturer Emergency Telephone No.
N/A
Chemsico
8494 Chapin Industrial Dr.
St. Louis, MO 63114
For Chemical Emergency: 1-800-633-2873
For Information: 1-800-332-5553
Prepared by: H.L. Pauls
Date Prepared: October 24, 2004
II Hazardous Ingredients/Identity Information III Physical and Chemical Characteristics
Chemical % OSHA PEL ACGIH TLV
Asphalt 16.0 NE 5 mg/m
3
(fumes)
CAS #64742-93-4
Xylene 3.0 100 ppm 100 ppm
CAS #1330-20-7
Mineral Spirits 11.0 500 ppm 100 ppm
CAS #8012-95-1
Isobutane 4.0 NE NE
CAS # 75-28-5
Propane 6.0 1000 ppm NE
CAS # 74-98-6
Appearance and Odor: Coarse fan spray. Black wet
film. Asphaltic odor.
Boiling Point: NA
Melting Point: NA
Vapor Pressure: 120 psig @ 54°C/130°F
Specific Gravity: 1.03 (H
2
0=1)
Vapor Density: greater than 1 (Air=1)
% Volatile (by vol.): 72%
Solubility in Water: 48%
Evaporation Rate: less than 1 (Butyl Acetate=1)
IV Fire and Explosion Hazard Data V Reactivity Data
Flash Point: 145°F (TCC)
Flame Extension: 8" ( Level 1 Aerosol)
Flammable Limits: N/A
Autoignition Temp: N/A
Fire Extinguishing Media: Water Fog, Carbon Dioxide
DryChemical
Decomposition Temp: N/A
Special Fire-Fighting Procedures: Keep containers cool. Use
equipment or shielding required protecting personnel
against bursting, rupturing or venting containers.
Unusual Fire and Explosion Hazards: At elevated
temperatures (over 54°C/130°F), containers may vent,
rupture or burst. Also see Section V.
Stability: Stable
Polymerization: Will not occur
Conditions to Avoid: Temperatures over 130°F
Incompatible Materials: Strong oxidizers.
Hazardous Decomposition
or Byproducts: N/A
VI Health Hazard Data VII Precautions for Safe Handling and Use
Ingestion (Swallowing): Harmful or fatal if swallowed. First Aid:
Consult a physician.
Skin Contact: May cause skin irritation. First Aid: Wash
contaminated skin with soap and water.
Eye Contact: May cause eye irritation. First Aid: Flush eyes
with plenty of water.
Inhalation Toxicity: Avoid breathing vapors. First Aid:
Remove to fresh air.
Special Notes: None
Health Conditions Aggravated by Exposure: None Known
Ingredients listed by NTP, OSHA or IARC
as Carcinogens or potential carcinogens: None
Steps to be Taken in Case Material is Released or Spilled:
Avoid breathing vapors. Remove ignition sources. Avoid
skin contact with liquid.
Waste Disposal:
Do not puncture or incinerate containers. Give empty,
leaking or full containers to a facility qualified to dispose of
pressurized containers.
Handling & Storage Precautions:
Do not store where temperatures can exceed 54°C/130°F.
VIII Control Measures IX Transportation Data
Read and follow label directions. They are your best guide to
using this product effectively, and give necessary safety
precautions to protect your health.
DOT: Consumer Commodity, Hazard Class ORM-D
(Limited Quantity Exception)
IMDG: Aerosols (Maximum 1 Liter), Hazard Class 2, UN -1950,
Packing Group III
IATA: Aerosols, Flammable (Each Not Exceeding 1 Liter
Capacity), Hazard Class 2.1. UN-1950, Packing Group
III
The information and statements herein are believed to be reliable but are not to be construed as warranty or representation for which
we assume legal responsibility. Users should undertake sufficient verification and testing to determine the suitability for their own
particular purpose of any information or products referred to herein. NO WARRANTY OF FITNESS FOR A PARTICULAR PURPOSE IS MADE.