Instructions / Assembly

9
To place the stakes manually, assemble the auger by screwing the handle onto the auger
shaft tightly. To create a hole, push down and twist the auger clockwise 3 to 5 revolutions.
Then pull the tool out of the hole and tap on the ground or scrape to remove accumulated
soil. Twisting the auger more than 3 to 5 revolutions may make it difficult to remove. Repeat
as necessary until the hole is approximately 7 inches deep. To use the auger in an electric
drill, insert the shaft into the drill. Drill a few inches at a time, then pull the auger from the
hole and remove accumulated soil. Repeat as above. Read and follow all instructions
provided by your drill manufacturer, including proper eye protection. Keep children
and pets away during installation. Notice: Do not use auger for any purpose other
than installation of the termite killing stakes.
Before inserting the stake in the hole, slide the locator shield into place
with the Spectracide Terminate
®
logo facing up. The stake should be
inserted so that the bottom of the locator shield is even with ground
level as shown. The locator shields will help you locate the stakes by
preventing grass overgrowth.
Note: Do not install this product in wells. Do not install this product
into insecticide-treated soil or spray this product with any insecticide.
Do not place stakes in an area where there is the possibility of
contaminating food or surfaces that come in contact with food. Do not
install this product in contact with water.
• If you have sandy or hard packed clay soil, you may need to moisten the ground before
you begin digging. Never hammer directly on the stakes. You could also use some other
tool to dig the holes for the stakes, but always check to be sure the locator shield is at
ground level.
•
When placing the stakes,
use a system to help you remember where you placed each
stake. For example, you could start from a corner of your house and place a stake every
three steps around the foundation of the house. You may also want to make a small mark
on the foundation of your house indicating the location of each stake.
Step 5:
After the stakes have been installed, be sure to note the installation date and location of
each stake on your drawing.
If you live in an area suspected to contain Formosan subterranean termites, these areas
will require more frequent inspection. See page 5 to learn more about Formosan termites.
Step 6:
Fill out and mail the enclosed warranty registration card.
Step 7:
Using the drawing to locate the stakes, check the stakes for
termite activity when the pop-up indicator is seen by pulling
the stake from the ground. Look for signs that the bait has been
eaten or that termites are present inside the stake. The locator
shield will also help make removal of the stakes easier. It is
important to check the stakes every three months. If you live in
an area suspected to contain Formosan subterranean termites,
the frequency of stake inspection should be increased to once
a month.