User Manual

Appropriate RF safety/installation information
The System IP600-ISM base is intended to be installed by authorized personal.
The base station shall be installed in accordance with FCC rules.
The System IP600-ISM shall be placed at a location in such way, that there is at
least 20 centimetres between the base transmitter and the users body or
any other nearby persons.
Safety Instructions
Important Safety Instructions and Product Information
Before using your telephone equipment, you should always follow basic safety instruction to reduce
the risk of fire, electrical shock and injury to persons, and damage to property.
1 Read and understand all instructions.
2 Follow all warnings and instructions including those marked on the product.
3 Unplug this product before cleaning. Do not use liquid cleaners or aerosol cleaners. Use damp cloth
for cleaning.
4 Do not install the telephone equipment in the bathroom or near a wash bowl, kitchen sink, or
laundry tub, in a wet basement, or near a swimming pool.
5 Slots or openings in the cabinet back and bottom of the equipment are provided for ventilation to
protect it from over-heating. These openings must not be blocked or covered.
6 The product should be operated only from the type of power source indicated on the instructions. If
you are not sure of the type of power supply, consult your dealer or local power company.
7 Do not overload wall outlets and extension cords as this can result in fire or electrical shock.
8 Never push objects of any kind into this product through cabinet slots as they may touch dangerous
voltage points or short out parts that could result in fire, electrical shock, or injury. Never spill liquid
of any kind into this product.
9 To reduce the risk of electrical shock or burns, do not disassemble this product. Opening or
removing covers may expose you to dangerous voltages, dangerous electrical current, or other risks.
Incorrect reassemble can cause electrical shock when the appliance is subsequently used. If the
product need repair, consult your dealer.
10 Refer servicing to qualified service personnel under the following conditions:
AQ If liquid has been spilled into the product
BQ If the product has been exposed to rain or water
CQ If the product does not operate normally when following the operating instructions in the manual.
Adjust only those controls that are covered by the operation instructions. Improper adjustment of
other controls may result in damage and will often require extensive work by qualified service
personnel to restore the product to normal operation.
DQ If the product has been dropped or cabinet has been damaged.
EQ If the product exhibits a distinct change in performance.
11 Avoid using telephone during an electrical storm. There may be a risk of electrical shock from
lightning.
12 Do not use the telephone to report a gas leak in the vicinity of the leak.
13 Do not place the base or charger near microwave ovens, radio equipment, or non-ground
connected televisions. These appliances may cause electrical interference to the base or handset
14 The charger must be placed on a hard, flat surface and connected to a functional 120 volt AC
power netadapter and plug the adapter into the power outlet.
15 This telephone will not operate in the event of a blackout. Please keep a backup phone for
emergencies.
Intrinsic safety
Do not use the standard KIRK handset in conditions where there is a danger of electrically ignited
explosions.