User Manual
Table Of Contents
- 1 Getting Started
- 1 About Your 5020 / 5040 Handset
- 1 Basic Handset Options
- 1 Making Calls
- 1 Answering Calls
- 1 During Calls
- 1 Using the Menu
- 1 Phone Book
- 1 Call Register
- 1 Messages
- 1.1 Writing and Sending a New Message
- 1.2 Saving a New Message in Outbox
- 1.3 Saving a New Message as a Template
- 1.4 Saving a Received Message as a Template
- 1.5 Sending Messages Using Templates
- 1.6 Reading a Message
- 1.7 Replying a Message
- 1.8 Forwarding a Message
- 1.9 Resending a Message
- 1.10 Erasing a Single Template
- 1.11 Erasing a Single Message
- 1.12 Erase All Read Messages from Inbox
- 1.13 Erase All Messages from Inbox
- 1.14 Erase All Messages from Outbox
- 1.15 Erase All Messages
- 1 Status
- 1 Settings
- 1.1 Ringing Volume
- 1.2 Ringing Tone
- 1.3 Alerting Volume
- 1.4 Vibrator
- 1.5 Silent Mode
- 1.6 Auto Key Lock
- 1.7 Backlight
- 1.8 Auto Answer
- 1.9 Out of Range
- 1.10 Bluetooth (only KIRK 5040)
- 1.10.1 Activate Bluetooth Function
- 1.10.2 Pair Wireless Headset with the Handset
- 1.10.3 Deactivate Bluetooth
- 1.10.4 Activate Bluetooth Again
- 1.10.5 Disconnect Wirelees Headset.
- 1.10.6 Connect Wireless Headset again
- 1.10.7 Remove Wireless Headset from the Device List
- 1.10.8 Auto Connect
- 1.10.9 Wireless Headset Volume
- 1.10.10 Switch Between Wireless Headset and Handset
- 1.10.11 Last Number Redial
- 1.11 Advanced...
- 1 General Information
10
Note: The product label, including the CE logo, can be found in the battery
compartment.
1.5 Charging Battery
When charging battery for the first time, it is necessary to leave handset in charger for
14-16 hours for the battery to be fully charged.
During normal operation, it takes approximately 6 hours to charge the handset from
fully discharged to its full capacity. Turning the backlight off reduces charging time
with approximately 2 hours (refer to “Turning Backlight Off” on page 52).
• Place handset in charger.
For correct charging, be sure the room temperature is between 0°C/32°F and 40°C/
104°F. Do not place the handset in direct sunlight. The battery has a built-in heat sensor
which will stop charging if the battery temperature is too high.
If the handset is turned off when placed in charger, nothing indicates the charging.
There will be no reaction on incoming calls.
If the handset is turned on when charging, the display shows the blue charging icon
in the status bar. The charging icon is replaced by the green fully charged icon ,
when the battery is fully charged (when handset is removed from charger, the charg-
ing icon disappears). The handset will not vibrate. Auto answer is inactive. The hand-
set reacts normally for incoming calls.
It is necessary to recharge battery when display shows the battery low icon , or if the
handset cannot be turned on.