User Manual
Table Of Contents
- 1 Getting Started
- 1 About Your 5020 / 5040 Handset
- 1 Basic Handset Options
- 1 Making Calls
- 1 Answering Calls
- 1 During Calls
- 1 Using the Menu
- 1 Phone Book
- 1 Call Register
- 1 Messages
- 1.1 Writing and Sending a New Message
- 1.2 Saving a New Message in Outbox
- 1.3 Saving a New Message as a Template
- 1.4 Saving a Received Message as a Template
- 1.5 Sending Messages Using Templates
- 1.6 Reading a Message
- 1.7 Replying a Message
- 1.8 Forwarding a Message
- 1.9 Resending a Message
- 1.10 Erasing a Single Template
- 1.11 Erasing a Single Message
- 1.12 Erase All Read Messages from Inbox
- 1.13 Erase All Messages from Inbox
- 1.14 Erase All Messages from Outbox
- 1.15 Erase All Messages
- 1 Status
- 1 Settings
- 1.1 Ringing Volume
- 1.2 Ringing Tone
- 1.3 Alerting Volume
- 1.4 Vibrator
- 1.5 Silent Mode
- 1.6 Auto Key Lock
- 1.7 Backlight
- 1.8 Auto Answer
- 1.9 Out of Range
- 1.10 Bluetooth (only KIRK 5040)
- 1.10.1 Activate Bluetooth Function
- 1.10.2 Pair Wireless Headset with the Handset
- 1.10.3 Deactivate Bluetooth
- 1.10.4 Activate Bluetooth Again
- 1.10.5 Disconnect Wirelees Headset.
- 1.10.6 Connect Wireless Headset again
- 1.10.7 Remove Wireless Headset from the Device List
- 1.10.8 Auto Connect
- 1.10.9 Wireless Headset Volume
- 1.10.10 Switch Between Wireless Headset and Handset
- 1.10.11 Last Number Redial
- 1.11 Advanced...
- 1 General Information
67
Before using your telephone equipment, you should always follow basic safety instruc-
tion to reduce the risk of fire, electrical shock and injury to persons, and damage to
property.
1. Read and understand all instructions
2. Follow all warnings and instructions including those marked on the product
3. Unplug this product before cleaning. Do not use liquid cleaners or aerosol cleaners.
Use damp cloth for cleaning
4. Do not install the telephone equipment in the bathroom or near a wash bowl,
kitchen sink, or laundry tub, in a wet basement, or near a swimming pool
5. Slots or openings in the equipment are provided for ventilation to protect it from
over-heating. These openings must not be blocked or covered.
6. The product should be operated only from the type of power source indicated on
the instructions. If you are not sure of the type of power supply, consult your
dealer or local power company.
7. Do not overload wall outlets and extension cords as this can result in fire or electri-
cal shock.
8. Never push objects of any kind into this product through cabinet slots as they may
touch dangerous voltage points or short out parts that could result in fire, electrical
shock, or injury. Never spill liquid of any kind into this product.
9. To reduce the risk of electrical shock or burns, do not disassemble this product.
Opening or removing covers may expose you to dangerous voltages, dangerous
electrical current, or other risks. Incorrect reassemble can cause electrical shock
when the appliance is subsequently used. If the product need repair, consult your
dealer.
10. Refer servicing to qualified service personnel.
11. Avoid using telephone during an electrical storm. There may be a risk of electrical
shock from lightning.
12. Do not use the telephone to report a gas leak in the vicinity of the leak.
13. Do not place the base or charger near microwave ovens, radio equipment, or
non-ground connected televisions.
These appliances may cause electrical interference to the base or handset
14. The charger must be placed on a hard, flat surface and connected to a functional
120 volt AC power source depending on the country of use.
The WEEE Marking on this equipment indicates that the
product must not be disposed of with unsorted waste,
but must be collected separately.