Reapeter 1405 7301 ed1 28/09/01 11:41 Page 1 Instructions for installation and configuration of a Repeater
Reapeter 1405 7301 ed1 28/09/01 11:41 Page 2 We recommend you to use the instructions in point A. A. To install a Repeater you will need a configuration programme, the Repeater programming kit and documentation of how to connect the cables. You will find this description at your dealer. Download of the programme and documentation is free of charge. The documentation and programme may also be requested from your dealer.
Reapeter 1405 7301 ed1 28/09/01 11:41 Page 4 You can use instructions in point B for alternatively configuration method (if you do not have access to the tool and a PC) B. 1 Turn on the base station and a subscribed handset. 2 Turn on the Repeater (WRFP) for more than 1 second and less than 5 seconds (note 1). Turn off the WRFP and turn it on again. The WRFP is now in subscription mode. This is indicated by a flashing LED immediately after power is switched on.
Reapeter 1405 7301 ed1 28/09/01 11:41 Page 6 6 Select Radio Part Number (RPN). Hook off and press a number on the handset in the range 000-250. When the number is accepted by the WRFP this is acknowledged by the LED flashing the number of times corresponding to the digit. Digits may be entered several times. Only the last accepted digit is recorded. If you are using more WRFPs on the same base station they must have different RPNs. 7 Accept subscription identities by hook off and pressing the *-key.
Reapeter 1405 7301 ed1 Note 3: 28/09/01 11:41 Page 8 If the #-key is used to accept the subscription identities an inspection tone is enabled. The WRFP will then, when relaying connections, insert a short tone every 2 seconds in the audio path to Handsets. This feature can be used for inspection and verification of the WRFP placement. When the operation has been verified the inspection tone should be disabled. Performing step 2 only of the subscription procedure will disable the inspection tone.
Reapeter 1405 7301 ed1 6 7 8 9 28/09/01 11:41 Page 10 The product should be operated only from the type of power source indicated on the instructions. If you are not sure of the type of power supply, consult your dealer or local power company. Do not overload wall outlets and extension cords as this can result in fire or electrical shock.
Reapeter 1405 7301 ed1 28/09/01 11:41 Page 12 13 Do not place the unit near microwave ovens, radio equipment, or non-ground connected televisions. These appliances may cause electrical interference to the base or handset 14 The unit must be installed on a hard, plane surface and connected to a functional 120 volt AC power netadapter and plug the adapter into the power outlet 15 The system will not operate in the event of a blackout.
Reapeter 1405 7301 ed1 28/09/01 11:41 Page 14 this equipment, or equipment malfunctions, may give the telecommunications company cause to request the user to disconnect the equipment. Users should ensure for their own protection that the electrical ground connections of the power utility, telephone lines and internal metallic water pipe system, if present, are connected together. This precaution may be particularly important in rural areas.
Reapeter 1405 7301 ed1 28/09/01 11:41 Page 16 harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures: - Reorient or relocate the receiving antenna.
Reapeter 1405 7301 ed1 28/09/01 11:41 Page 18 purchase receipt, the warranty period shall be one (1) year from the date of manufacture. Repair or replacement of the product is your sole and exclusive remedy. ber, improper electrical voltages or currents, repair, alteration or maintenance by any person or party other than our authorized service facility, or any violation of instructions furnished by us. If the product is repaired, reconditioned component parts or materials may be used.
Reapeter 1405 7301 ed1 28/09/01 11:41 Page 20 PURPOSE, SHALL BE LIMITED TO THE DURATION OF THIS WRITTEN LIMITED WARRANTY. WE DISCLAIM ANY LIABILITY FOR DAMAGES FOR LOSS OF USE OF THE PRODUCTS, LOSS OF TIME, INCONVENIENCE, INJURY TO ANY PERSON, OR DAMAGE TO PROPERTY CAUSED BY THE PRODUCT, LOSS OF REVENUE OR PROFIT OR DAMAGES FOR ANY FAILURE TO PERFORM. IN NO EVENT SHALL WE BE LIABLE FOR ANY SPECIAL, INCIDENTAL, PUNITIVE OR CONSEQUENTIAL DAMAGES EVEN IF WE ARE ADVISED OF THE POSSIBILITY OF SUCH DAMAGES.
28/09/01 11:41 1405 7301-HD, ed.1 . Reklame & Tryk A/S .
