User's Guide

Table Of Contents
User Guide for the Envoy Data Link
Document Number: UG-15000 Rev. A Page 44 of 173
The aircrew can edit a queued FANS report by pressing the corresponding LSK to open the report
detail.
All ATC reports that have been sent can be viewed in the ATC MSG LOG. All queued reports are
in the ATC REPORT Menu.
When the aircraft is on ground, all ATC reports are automatically cleared after 10 minutes of being
IN.
Note One-time and event-triggered reports, such as OOOI reports and ADS-C reports (FANS
only), differ from these CPDLC reports. OOOI reports are described in Section 4.1 and
ADS reports are described in Section 6.3.5.
Figure 3-10 ATC REPORT Menu for ATN (left) and FANS (right)
The Envoy processes these reports for ATN and FANS, as described in Table 3-8 and Table 3-9:
Table 3-8 ATC REPORT (ATN)
The following table summarizes the automated reports available in FANS:
Table 3-9 (ATC) REPORTS (FANS)
Report Title
Section
Default DM
Queued Report Options
LEAVING [level]
3.5.2.2
Response page Selection list:
ARM RPT (default)
MAN RPT
ARMED and MAN reports are
queued to the REPORT list when a
WILCO response is sent.
ARMED reports can be disarmed
(set to MANUAL) from the REPORT
list by pressing the associated LSK
twice (PRESS LSK TO DISARM
notification message).
Queued reports that are MANUAL
can be edited but not re-ARMED
Disarmed reports can be removed
by pressing the DEL key and then
pressing the associated LSK.
BACK ON ROUTE and CLEAR OF
WEATHER must be manually
armed.
CLIMBING TO [level]
0
DESCENDING TO [level]
3.5.2.6
PASSING [position]
--
REACHING BLOCK [level]
TO [level]
3.5.2.4
MAINTAINING [level]
3.5.2.3
BACK ON ROUTE
--
Response page Selection list:
<blank> (default)
MANUAL
These queued reports can be
edited from the REPORT list by
pressing the associated LSK and
modifying the UM response.
[remainingFuel] OF FUEL
REMAINING AND
[remainingSouls] SOULS
ON BOARD
3.5.5
CLEAR OF WEATHER
--
Report Title
Section
Description
ATC REPORT ALT
3.5.2.1
Present/preferred levels