Reference Guide

A B
C D
Smart home
system setup
15
Add the lock to your smart home system
Initiate the process to add the
lock to your system at your smart
home controller. Refer to your
smart home system instructions
for more information.
SmartStart Enabled Products
SmartStart enabled products
can be added into a Z-Wave
network by scanning the
Z-Wave QR Code present on
the product with a controller
providing SmartStart inclusion.
No further action is required
and the SmartStart product will be
added automatically within 10 minutes of
being switched on in the network vicinity.
At this time, you may be prompted
by your smart home system to
enter the 5-digit pin found on the
label of the interior assembly. If not,
proceed to step D.
When prompted by your smart home
system to add the lock, press button
“A” on the lock interior one time.
The red LED will illuminate when the
lock enters Add Mode.
If successful, re-name the lock in
your system (if applicable).
If unsuccessful, follow your
system’s instructions to remove
the lock from the controller and
any other network, then press
button “A” on the lock one time.
Perform steps A-C again.
If still unsuccessful, consult the
Programming and Troubleshooting
Guide on the [NEED NAME] page
at kwikset.com.
Button
“A”
5-digit
pin
QR
code