User's Guide

2 / 4
21/8"
54 mm
11/2"
38 mm
actual
size
T
What is the diameter of the hole in the door?
Locate the screws for step 3C and keep them within reach.
Install the exterior keypad and mounting plate.
A
B
C
Diameter is 21/8"
(54 mm)
Diameter is 11/2"
(38 mm)
or
“D” is required for installation.
Install “D” on “F”.
“D” is not needed for
installation. Discard “D”.
The cable goes
underneath the latch.
Support the exterior
assembly during mounting
plate installation.
Route the cable
through the center
hole, then push it into
the bottom hole.
Insert the key and
test the latch. If the
latch does not
extend or
retract
smoothly, adjust
the screws (T).
Remove the key
when inished,
and make sure
the latch bolt is
fully extended.
Keep parallel to the
edge of the door.
Tighten
screws
evenly.
a
c
b
d
U
actual
size
U
(2x)
Ensure the turnpiece shaft is pointing up, and remove the interior cover and
battery pack from the interior assembly.
Install the interior assembly onto the mounting plate.
A B
a
c
b
d
If the turnpiece shaft is pointing down,
rotate the turnpiece until you hear it click.
You may need to apply some force.
Once the turnpiece shaft is correctly
oriented, remove the cover again.
Make sure turn
piece shaft is
rotated as shown.
Do not install
batteries
until step 5.
Ensure tight cable
connection.
Lay the excess cable
lat inside the bottom of
the interior housing.
align
L
a
c
b
d
bottom
hole
M
L
L
L
K
If turnpiece shaft is not oriented
correctly, put the cover back on and
rotate the turnpiece as shown in step C.
Remove the interior
cover from the
interior assembly.
D
D
F
F
G
T
T (2x)
T
E
3
Install the exterior keypad
4
Install the interior assembly