User Manual

Chapter 2: Quick Start for Experienced Users
U ser 's M a n u a l 0 300 21 5- 03 R ev. A
2-4
The ter minal b lock layout is shown below:
Figure 2-1
N/C
Ch1-iRtn
N/C
Ch3-iRtn
Ch0+
N/C
Ch0-iRtn
Ch0-
Ch1+
N/C
Ch2-iRtn
Ch2-
Ch3+
Ch3-
N/C
N/C
Ch2+
Ch1-
Step 4: Configure the module for the
proper controller.
Reference
Chapter 4 (Configuring the IF4IH for
CompactLogix Using
RSLogix 5000) or Chapter 5 (Configuring
the IF4IH fo r a MicroLogix 1500 Using
RSLogix 500)
Step 5: Configure the module. Reference
Chapter 6 (Module Data, Status, and
Channel Configur atio n)
The configuration file is typically modified using the program ming software compatible
with your controller. It can also be modified through the control program, if supported by
the controller. See Section 6.4 Mod ule
Configuration for more information.
Step 6: Go thro ugh the startup
procedure. Reference
Chapter 9 (Diagnostics and
Troubleshooting)
1. Apply power to the controller system.
2. Download your program, which contains the Isolated HART module configuration
settings, to the controller.
3. Put the controller in Run mode. During a normal start-up, the module status LED
turns on.
NOTE: If the module status LED does not turn on, cycle power. If the condition
persist s, contact your local distributor or Spect rum Co ntrols for assistance.