Instructions / Assembly

Nuevo/Deco
INSTALLATION INSTRUCTIONS
For quick and easy installation of your folding door, read these
instructions thoroughly. A few minutes of prior planning will make the
job easier and will insure years of trouble-free use.
The Tools You Will Need
You will need a small #1 Phillips screwdriver, a tape measure, a small
nail, and a 3/32” drill bit for pilot holes, a hacksaw or ne tooth saw
(saw needed to trim top track for the appropriate width or to trim
height of panels if door is less than 80” high); and masking tape
(to secure doors if trimming is necessary.)
Make Sure All The Following Parts Are Included With Your Folding Door:
Handle
1 Overhead
Track
2 Handles Pins
12 Track &
Anchor
Screws (3/4”)
3 (3/4”) Screws
(for Magnet
Plate)
Striker
Plate
Female & Male
Connectors
1 T Style
Top-Glide
8 Top
Glides
Track
Lubricant
9 Female & Male Door Rings
(Per Kit)
(Choose Your Color Option)
Door Parts Location
T-Top
Glide
Overhead Track
Striker
Plate
Handle
Lead
Edge
of Door
Anchor
Panel
Track
Glides
Door Glides
Rings
SINGLE DOOR INSTALLATION
1. Measure the Door Opening
If the height of your door opening is approximately
80”, you will not need to alter the door itself. If the
opening is less than 80” high, the door may be
shortened by sawing o excess from the bottom of the
door panels (end without holes).
If the opening is less than 80” high: Stack the door
panels together and cut with a hacksaw or ne tooth
saw. Cut the overhead track 1/8” shorter than the
width of the opening.
2. Install the Overhead Track
Position the overhead track on the top of the
door opening so that it is straight and centered.
After making a pilot-hole (with a nail or 3/32”
drill), drive a 3/4” track screw through the
screw hole nearest the center of the track. Do
not tighten. (Tape may be used to hold the
track in place while you mark and drill.)
3. Install the Handles
Choose color handle set. Tap the
two handles attachment pins into
one handle, then t the pins through
the door panel holes. Press the
other handle onto the pins. If
necessary, you may back one
handle with a solid object and tap
the other handle alternately over
each pin area until the handles are
seated. Do not strike the middle of either handle
4. Install the Door Rings
Choose color ring set. Allign the Male
and Female Door Rings with the door
hanging holes located at the top of the
door. Apply even pressure until rings lock
together.
5. Install the T Top Glide
To secure the lead edge top glide, place the T
shaped part inside the lead edge and align the
holes. Then insert the female section from the
outside hole through the hole in the T shaped
glide through the other side of the lead edge.
Then insert the threaded male screw into the
female part and tighten until snug.
6. Connect Glides to
Door Rings
Making sure clips are all facing same
direction, fasten Top Glides onto Door
Rings.
Door Hardware Color
You may choose between 2 color options for your door
hardware application.
Handles
Rings & Glides
2 Handles Per Hardware Kit
(Choose Your Color Option)