Instructions / Assembly

Metro/Century Installation Instructions
For quick and easy installation of your folding door, read
these instructions thoroughly.
The Tools You Will Need
You will need a Drill, Phillips screwdriver bit, 3/32” drill bit for
pilot holes, small Phillips head screwdriver, tape measure,
pencil, ne tooth hacksaw (for cutting the top track), safety
glasses and ne sandpaper (can be used to smooth edges
after cutting top track) and a level.
Make sure all of the following Parts are
included before you begin:
Door Parts Location
SINGLE DOOR INSTALLATION
1. Measure the Door Opening
Measure the height and width of your nished opening. This
door ts openings that are 24” to 36” wide and 80” high. The
door height cannot be trimmed or altered.
2. Install the Top Track
Cut the top track 1/8” shorter than the width of the nished
opening.
Position the top track in the top of the door opening so that it
is straight and centered.
After making a pilot-hole (with a 3/32” drill bit), insert a 1”
track screw through the pre-drilled hole nearest the center of
the track. Do not fully tighten. (Tape may be used to hold the
track in place while you mark and drill.)
3. Attach the Handle
Take the female
handle and separate
it into two pieces.
Take one of the
handle screws and
put it through the
back of the inner
piece. Insert the
screw through the
top pre-drilled han-
dle hole on the lead
edge. Take the male
handle and line it up
with the screw shaft
on the other side of
the door. Tighten
with screwdriver until
it catches. Do not
tighten fully. Repeat
these steps for the bottom of the handle then fully tighten the
2 screws. Snap the cover back onto the female handle.
1 Ea.
Male
Handle
1 Ea.
36” Top Track
1 Ea.
Closure
Channel
1 Ea.
Anchor
Channel
1 Ea. Locking Clip
6 Ea. (1”)
Track Screws
14 Ea. (1”)
Flat Head
Screws
2 Ea.
Handle
Screws
1 Ea.
Locking Clip Screws
Anchor
Channel
Top Track
Closure
Channel
Locking
Clip
Handle
1 Ea.
Female
Handle
Top Glide
Anchor
Panel
Lead
Edge