Installation Guide

ManualsBrandsSpectrum ManualsAccordion DoorsWF4880NO

Opening

Width

Opening

Height

Right/Left

Hand Stack

Latch Style

Single/Double End

Door Series

Number and Length

of Track Pieces

Order Number

Example Label

Your label will look similar but have your unique information

Sample

Woodfold Mfg., Inc

P.O. Box 346

Forest Grove, OR 97116

Voice [503] 357-7181

Fax: [503] 357-7185

www.woodfold.com

Door InstallatIon

Door SerieS: 140, 220

BulletIn Install140-120906

Read and understand these instructions before proceeding!

It saves frustration!

Beginning installation before checking things out is discouraged!

Measure Twice - Cut Once so to speak

1 PreParation

Preliminary Examination

Conrm the match of the packaged door to the intended

opening. The example label to the right shows the location

of the critical information.

Inspect the packaging. If the pack-

age was damaged when it arrived,

contact the shipping carrier rst,

then notify Woodfold.

Lay out the contents on a at surface near the opening

where the door is to be installed.

The package(s) contents should include

; Door

; Track Section(s)

; Hardware packet (Screws etc.)

; These instructions (Yes, yes, we know you had to nd them if you’re reading them, but we like to be complete.)

; A copy of the shipping label with all the information you need if you have to call Woodfold for any reason. Hold on to it for

future reference.

Caution! The factory greased the track for smooth operation! Hands and tools can spread

the grease all over, so please be careful.

Summary of content (4 pages)

PAGE 1
Door Installation Door Series: 140, 220 Bulletin Install140-120906 Read and understand these instructions before proceeding! It saves frustration! Beginning installation before checking things out is discouraged! Measure Twice - Cut Once so to speak Preliminary Examination Example Label Your label will look similar but have your unique information Opening Width Confirm the match of the packaged door to the intended opening. The example label to the right shows the location of the critical information.
PAGE 2
Double Ended Door Stacking: Double Ended (DE), Left Handed (LH), Right Handed (RH) For the purpose of these instructions, doors come in three basic configurations: Double Ended (DE), Left Hand Stacked (LH) and Right Hand Stacked (RH). DE doors have Lead Panels (Panel with Swept Wing Handle) at each end of the Panel set. LH and RH doors have a Lead Panel on one end and a Mounting Panel on the other end. Left or Right handing is determined when the door is viewed from the front.
PAGE 3
This next section is the most critical. Improperly installing the Mounting Panel results in the majority of trouble calls to Woodfold. Repeat after me: I will read this section. I will read this section. 3. Mounting Panel If your door is a LH or RH stacked door or a pair (see Page 2) you need to read this Section. If Your door is DE, forget the warning above and skip ahead to Section 4. Push the door to the side that will be fastened permanently to the wall.
PAGE 4
Magnetic Latch Swept Wing Handle Center the Strike Plate on the magnet with the adhesive side out. Remove the protective tape from the adhesive backing and push the door firmly shut. When you reopen the door, the strike plate should stay, temporarily stuck, in position. Screw down the strike plate using 1½” #6 Flat head screws. Door Jamb Magnetic Latch Capsule #6 x 1½” Flat Head Screw Steel Strike Plate Check it out! Open and close the door a few times then step back and admire your work.