User's Manual

3. Depending on the existing IDE devices (if any) on your system, follow the direction below to configure
Master/Slave/Cable Select mode of this product (Figure 2).
Figure 2: Master/Slave/Cable Select mode configuration
4. Insert this product into an IDE port on the motherboard (Figure 3).
5. Connect the Black SATA connector on the adapter to the SATA device using a SATA cable (Figure 3).
Figure 3: SATA Device to motherboard’s IDE Port connection
6. Connect the 4-pin FDD power connector of the product to the motherboard Power Supply Unit (PSU).
If there is no 4-pin FDD power plug available on the PSU, please use the included power extension Y-
cable to convert the 4-pin HDD power plug to a 4-pin FDD power plug
7. Place the computer’s cover back to the chassis and then turn your computer on.
All specifications and information are subject to change without prior notice
All logos and trademarks referenced are the registered trademark of their respective owners