Instruction Manual

Washer Symptom Possible/Cause Solution

Control not responding to keypad selections • Make sure Control Lock feature is off. If on, Control Lock light

will be lit.

• Press and hold Signal Keypad for three seconds to turn off.

Er, do on digital display • The control senses that the door is open during a running cycle.

• Unplug the machine to clear this code.

Er, dL on digital display • The control senses that the door has unlocked during a running

cycle.

• Unplug the machine to clear this code.

Er, dr on digital display • This code indicates that water is still in the washer at the end

of the cycle.

• Check the drain hose and drain receptacle to make sure they

are installed properly and not blocked.

• Foreign object trap in pump may be clogged. Clean the trap. Re-

fer to Maintenance section.

• Unplug the machine for 15 seconds to clear this code.

Er, FL on digital display • This code will appear if the washer has not reached the fill level

after 30 minutes during a wash or rinse fill.

• Make sure hot and cold water faucets are turned on.

• Make sure that the fill hoses are not kinked or twisted.

• Clean the screens in the water mixing valve and the filter

screens located at the faucet end of the fill hoses.

• Unplug the machine for 15 seconds to clear this code.

Er, nF on digital display • The washer has not filled to the proper water level.

• No or very little change in water level has been sensed within 5

minutes of the current fill.

• Make sure hot and cold water faucets are turned on.

• Make sure that the fill hoses are not kinked or twisted.

• Clean the screens in the water mixing valve and the filter

screens located at the faucet end of the fill hoses.

• Unplug the machine for 15 seconds to clear this code.

Er, OF on digital display • This code indicates the washer has filled to the overflow level.

• The machine will begin to attempt to pump water out if the

door is closed and locked.

• Foreign object trap in pump may be clogged. Clean the trap. Re-

fer to Maintenance section.

• If the code does not clear, unplug the machine and call for serv-

ice.

Er, PS on digital display • The control has detected trouble sensing the water fill level.

• Unplug the machine and call for service.

Er, dU on digital display • The control senses that the door will not unlock.

• Unplug the machine for three minutes to unlock the door.

• If the code appears again, call for service.

Troubleshooting

Part No. 804648R3