Installation guide

IMPORTANT: To prevent siphoning, do not place

any ribbed portion of the drain hose into the stand-

pipe.

3. Remove the beaded strap from accessories bag and place

around standpipe and drain hose, approximately 12 inches

[300 mm] down from the top of pipe. Refer to Figure 5 .

4. Tighten strap to hold hose to standpipe. This will prevent the

drain hose from dislodging from drain receptacle during use.

TLW2220N_SVG

1. Ribbed Portion of Drain Hose

2. Standpipe Adapter

3. Beaded Strap

4. Standpipe - 2 in. [51mm] or 1-1/2 in. [40 mm] Diameter

5. 36 in. [914 mm] Recommended Height

6. 12 in. [305 mm]

Figure 5

Low Standpipe Installation

If standpipe is lower than 36 inches [914 mm], you must install

No. 562P3 Siphon Break Kit. Refer to Figure 6 . This kit is avail-

able (as optional equipment at extra cost) through an authorized

dealer or parts distributor. Installation instructions are supplied

with the kit.

TLW2221N_SVG

1. 562P3 Siphon Break Kit

2. Standpipe

3. Drain Hose

Figure 6

Wall Installation

For installations of this type, the drain hose MUST be secured to

one of the fill hoses using the beaded strap from accessories bag.

Refer to Figure 7 .

NOTE: End of drain hose must not be below height of

cabinet top.

W329I_SVG

1. Beaded Strap (tape if necessary)

2. Standpipe Adapter

Figure 7

Laundry Tub Installation

For this type of installation, the drain hose MUST be secured to

the stationary tub to prevent hose from disloding during use. Re-

Installation

DO NOT COPY or TRANSMIT

8 Part No. 202955ENR2