N1127 Frontload Washers Operating Instructtion

ManualsBrandsSpeed Queen ManualsWasherLTS95A

801562

Maintenance

Lubrication

All moving parts are sealed in a permanent supply of

lubricant or are equipped with oilless bearings.

Additional lubrication will not be necessary.

Cold Weather Care

If the washer is delivered on a cold day (below

freezing), or is stored in an unheated room or area

during the cold months, do not attempt to operate it

until the washer has had a chance to warm up.

Vacations and Extended Non-Use

IMPORTANT: To avoid possible property damage

due to flooding, turn off the water supply to the

washer whenever there will be an extended period

of non-use.

Care of Your Washer

Use only a damp or sudsy cloth for cleaning the

control panel. Some cleaning product sprays may

harm the finish on the control panel or damage the

interior of the hood.

Wipe the washer cabinet as needed. If detergent,

bleach or other washing products are spilled on the

cabinet, wipe immediately. Some products will cause

permanent damage if spilled on the cabinet.

Do not use scouring pads or abrasive cleansers.

The wash drum and window will need no particular

care although they may need rinsing or wiping after an

unusual load has been washed. Outside of window can

be cleaned with household window cleaner.

Replacing Hoses

Hoses and other natural rubber parts deteriorate after

extended use. Hoses may develop cracks, blisters or

material wear from the temperature and constant high

pressure they are subjected to.

All hoses should be checked on a yearly basis for any

visible signs of deterioration. Any hose showing the

signs of deterioration listed above should be replaced

immediately. All hoses should be replaced every five

years.

Reinstallation of Shipping Materials

Remove front access panel by removing two screws.

Place the shock sleeves on all four shock absorbers.

Refer to illustration below.

Insert hooked end of shipping brace into the open slot

of the motor mount. Attach with bolts and washers.

Refer to illustration below.

Reinstall front access panel.

Refer to the INSTALLATION INSTRUCTIONS for

proper procedures whenever the washer is moved.

H336I

1 Shock Sleeves

2 Motor Mount

3 Bolts and Lockwashers

4 Hooked End of Shipping Brace