Owner Manual

ManualsBrandsSpeed Queen ManualsDryers27 Inch Commercial Dryer with 7 Cu. Ft. Capacity, Quantum Gold Pro Control, 5 Dry Cycles, Largest Door Opening, Reversible Door, Upfront Lint Filter, Durable Galvanized Steel Cylinder, and Integrated Meter Case: Gas - Coin Drop

Table Of Contents

2. After the dryer has operated for three minutes, the exhaust air

or exhaust pipe should be warm.

Gas Dryers

IMPORTANT: This operation is to be conducted by

qualified personnel only.

1. To view the burner flame, remove the lower front panel of the

dryer.

2. Close the loading door and start the dryer in a heat setting (re-

fer to the operation instructions). The dryer will start, the ig-

niter will glow red and the main burner will ignite.

IMPORTANT: If all air is not purged out of gas line,

gas igniter may go off before gas is ignited. If this

happens, after approximately two minutes igniter

will again attempt gas ignition.

IMPORTANT: If igniter does not light, make sure gas

is turned on.

3. After the dryer has operated for approximately five minutes,

observe burner flame through lower front panel.

4. Adjust the air shutter to obtain a soft, uniform blue flame. (A

lazy, yellow-tipped flame indicates lack of air. A harsh, roar-

ing, very blue flame indicates too much air.) Adjust the air

shutter as follows:

a. Loosen the air shutter lockscrew.

b. Turn the air shutter to the left to get a luminous yellow-

tipped flame, then turn it back slowly to the right to obtain

a steady, soft blue flame.

c. After the air shutter is adjusted for proper flame, tighten

the air shutter lockscrew securely.

5. Reinstall the lower front panel.

WARNING

To reduce the risk of serious injury or death, low-

er front panel must be in place during normal op-

eration.

W158

6. After the dryer has operated for approximately three minutes,

exhaust air or exhaust pipe should be warm.

Shut-off Valve Only Applicable on Certain Models

DRY2753N_SVG

1. Air Shutter Lockscrew

2. Air Shutter

3. 3.1 mm [1/8 in.] Pipe Plug (For checking manifold pressure)

4. Shut-off Valve Open Position

5. Shut-off Valve Closed Position

6. Shut-off Valve Handle

Figure 34

Vending

Meter Case

The factory mounted coin meter case does not include the service

door lock, coin slide (if applicable), coin drawer, coin drawer

lock or keys. These parts must be ordered (at extra cost) accord-

ing to the purchaser’s requirements direct from the manufacturer

of your choice.

Installation

DO NOT COPY or TRANSMIT

30 Part No. D514691ENR8