Installation Instructions

1. Lift dryer and place it on top of washer so dryer leveling legs
sit in notches in control cabinet.
2. Slide dryer backward until mounting holes in base line up
with holes in front of security cabinet.
3. Reconnect dryer wire harness. If needed, refer to unit’s wiring
diagram.
4. Tip dryer and replace two 7/16 inch screws and washers hold-
ing dryer to washer.
5. Reattach the control panel to the control cabinet using two
screws.
6. Replace dryer’s front access panel.
Order of Installation Steps
The proper order of steps must be followed to ensure correct in-
stallation. Refer to the list below when installing your unit.
1. Position unit near area of installation.
2. Remove the shipping materials.
3. Connect the fill hoses.
4. Connect the drain hose to the drain receptacle.
5. For gas models only, connect the gas supply pipe. Check for
gas leaks.
6. For electric models only, connect the electrical cord.
7. Connect dryer to exhaust system.
8. Position and level the unit.
9. Wipe out inside of washer and dryer drums.
10. Plug in the washer and dryer.
11. Check installation.
12. Start and run the dryer in a heat setting to verify dryer is heat-
ing.
Position Unit Near Installation Area
Move unit so that it is within 1.2 meters [4 feet] of the desired
area of installation.
CAUTION
Washer and dryer are not designed to be operated as
separated, side-by-side units.
W187
The stack washer/dryer must be installed on a ground or base-
ment floor, preferably concrete. If the flooring is wood construc-
tion, the flooring must meet a static load rating of 125 pounds
and a maximum dynamic load rating of 170 pounds per foot. If
the existing floor does not meet the dynamic load rating, the floor
must be re-enforced from below to meet the specification (maxi-
mum span = 16 feet, 2x10 joists, 16 inches on center, 1 inch sub
floor).
The stack washer/dryer must be installed on a smooth, non-slip
surface. Un-level tile and extremely slippery surfaces should be
avoided. Do not install the washer on carpeting, soft tile or other
weakly supported structures.
Failure to meet the minimum floor load and surface requirements
or installing the products on above ground floors can create dif-
ferent levels of vibration or movement that may appear like serv-
ice is required. Speed Queen will not cover scheduled repair serv-
ices where the installation requirements are not per specifica-
tions, nor can products be returned to the authorized dealer in
these cases.
Installation
©
Copyright, Alliance Laundry Systems LLC -
DO NOT COPY or TRANSMIT
10 Part No. 807638EN