Installation Instructions
Table Of Contents
- Table of Contents
- Dimensions
- Installation
- Before You Start
- Position Unit Near Installation Area
- Remove Shipping Materials
- Connect Fill Hoses
- Connect Drain Hose to Drain Receptacle
- Gas Dryers - Connect Gas Supply Pipe
- Electric Dryer Only - Connect Electrical Plug
- Connect Dryer Exhaust System
- Position and Level the Unit
- Reverse Door, if Desired
- Wipe Out Inside of Washer and Dryer Drum
- Plug In the Washer and Dryer
- Check Installation
- Check Heat Source
- Installer Checklist
D816I_SVG
L1 L2 L1 L2
15
16
5
2
2
3
4
8
9
12
13
10
11
7
6
1
14
1. A typical 30-Amp Three-Wire Receptacle NEMA Type 10-30R
2. 120 ± 12 V.A.C.
3. 240 ± 12 V.A.C.
4. Intermediate Fuse Box (may be omitted if service entrance box is fused)
5. Wall Receptacle
6. Power Supply
7. 3-Wire Earth/Ground Neutral 120/240 Volt, 60 Hertz AC 1 Phase Service Entrance Switch Box (Refer to NOTE above)
8. 30 Ampere Fuses or Circuit Breaker
9. Neutral Wire
10. Metallic or Non-Metallic Sheathed Cable (Copper Wire Only)
11. Power Cord (Not supplied with dryer)
12. Neutral
13. Terminal Block in Dryer
14. Intermediate Shut-Off Box (may or may not be fused)
15. Direct Connection
16. Power Cord Connection
Figure 12
1. Disconnect power to dryer.
2. Remove access cover from rear of dryer.
D695I_SVG
Figure 13
Installation
©
Copyright, Alliance Laundry Systems LLC -
DO NOT COPY or TRANSMIT
17 Part No. 807638EN