Installation Instructions
Table Of Contents
- Table of Contents
- Dimensions
- Installation
- Before You Start
- Position Unit Near Installation Area
- Remove Shipping Materials
- Connect Fill Hoses
- Connect Drain Hose to Drain Receptacle
- Gas Dryers - Connect Gas Supply Pipe
- Electric Dryer Only - Connect Electrical Plug
- Connect Dryer Exhaust System
- Position and Level the Unit
- Reverse Door, if Desired
- Wipe Out Inside of Washer and Dryer Drum
- Plug In the Washer and Dryer
- Check Installation
- Check Heat Source
- Installer Checklist
SWD1053N_SVG
4
5
3
2
6
1
1. Level
2. Wood Block
3. Rubber Foot
4. Leveling Leg
5. Locknut
6. Unit Base
Figure 22
Reverse Door, if Desired
NOTE: Doors with windows cannot be reversed.
The door on this dryer is completely reversible. To reverse door
proceed as follows:
1. Remove four hinge attaching screws.
D675I_SVG
Figure 23
2. Remove all nine screws.
D272P_SVG
Figure 24
3. Pull bottom of door liner out, then pull down, removing door
liner from door panel.
DRY1916N_SVG
B
A
Figure 25
4. Rotate door panel 180 degrees as shown.
D273P_SVG
Figure 26
5. Remove door strike from door liner and reinstall on opposite
side.
DRY1917N_SVG
Figure 27
Installation
©
Copyright, Alliance Laundry Systems LLC -
DO NOT COPY or TRANSMIT
23 Part No. 807638EN