Installation Instructions
Table Of Contents
- Table of Contents
- Dimensions
- Installation
- Before You Start
- Position Unit Near Installation Area
- Remove Shipping Materials
- Connect Fill Hoses
- Connect Drain Hose to Drain Receptacle
- Gas Dryers - Connect Gas Supply Pipe
- Electric Dryer Only - Connect Electrical Plug
- Connect Dryer Exhaust System
- Position and Level the Unit
- Reverse Door, if Desired
- Wipe Out Inside of Washer and Dryer Drum
- Plug In the Washer and Dryer
- Check Installation
- Check Heat Source
- Installer Checklist
6. Insert liner under flange on bottom of door, then push top of
door liner into place.
DRY1918N_SVG
B
A
Figure 28
7. Reinstall nine screws removed in Step 2.
DRY1919N_SVG
Figure 29
8. Using screwdriver, remove two door plugs, and reinstall on
opposite side of door opening.
D317S_SVG
Figure 30
9. Reinstall four hinge attaching screws, removed in Step 1.
D606I_SVG
Figure 31
Wipe Out Inside of Washer and Dryer
Drum
IMPORTANT: Prior to first wash, use an all-purpose
cleaner, or a detergent and water solution, and a damp
cloth to remove shipping dust from inside the drums.
SWD1012N_SVG
Figure 32
Installation
©
Copyright, Alliance Laundry Systems LLC -
DO NOT COPY or TRANSMIT
24 Part No. 807638EN