Installation Instructions
Table Of Contents
- Table of Contents
- Dimensions
- Installation
- Before You Start
- Position Unit Near Installation Area
- Remove Shipping Materials
- Connect Fill Hoses
- Connect Drain Hose to Drain Receptacle
- Gas Dryers - Connect Gas Supply Pipe
- Electric Dryer Only - Connect Electrical Plug
- Connect Dryer Exhaust System
- Position and Level the Unit
- Reverse Door, if Desired
- Wipe Out Inside of Washer and Dryer Drum
- Plug In the Washer and Dryer
- Check Installation
- Check Heat Source
- Installer Checklist
The following information applies to the state of Massachusetts,
USA.
• This appliance can only be installed by a Massachusetts li-
censed plumber or gas fitter.
• This appliance must be installed with a 910 mm [36 inch]
long flexible gas connector.
• A “T-Handle” type gas shut-off valve must be installed in the
gas supply line to this appliance.
• This appliance must not be installed in a bedroom or bath-
room.
©
Copyright, Alliance Laundry Systems LLC -
DO NOT COPY or TRANSMIT
4 Part No. 807638EN