Installation Instructions & Owner's Manual

FLW2335N_SVG
6
5
4
2
3
1
1. Leveling Leg
2. Washer Base
3. Level
4. Wood Block
5. Locknut
6. Rubber Foot
Figure 11
Wipe Out Inside of Wash Drum
Prior to first wash, use an all purpose cleaner or a detergent
and water solution and a damp cloth to remove shipping dust
from inside of the washer.
FLW2340N_SVG
Figure 12
Supply Injection Models Only - Connect
External Supplies to Washer
IMPORTANT: Undiluted chemical dripping can damage
the washer.
1. Remove two nozzles from accessories bag. Use either the 3/8
inch or 1/4 inch nozzles, depending on the diameter of the
dispenser tubing used.
2. Attach nozzles to rear of machine. Connection point located
on cabinet, above water mixing valve. Refer to Figure 13 .
3. Connect supply hoses to nozzles and secure with hose clamps
(obtain locally). Refer to Figure 13 .
NOTE: Hoses can be connected to either nozzle.
4. Refer to supply injection system instructions and label inside
washer junction box cover ( Figure 14 ) for electrical connec-
tion.
5. Do not attempt to make supply injection electrical connec-
tions to points other than those provided specifically for that
purpose by the factory.
6. Refer to supply injection system instructions for details on op-
eration.
Supply Injection System
Number of liquid supply con-
nections (1–Detergent and 2–
Softener)
2
Liquid supply connection
size, in. [mm]
3/8 [9.52] or 1/4 [6.35]
Table 1
WARNING
Wear eye and hand protection when handling chemi-
cals; always avoid direct contact with raw chemicals.
Read the manufacturer’s directions for accidental
contact before handling chemicals. Ensure an eye-
rinse facility and an emergency shower are within
easy reach. Check at regular intervals for chemical
leaks.
SW016
Installation
©
Copyright, Alliance Laundry Systems LLC -
DO NOT COPY or TRANSMIT
15 Part No. 805414ENR2