Consumer Manual

Two (2) lter
screen washers
Two (2) plain
rubber washers
Four (4) rubber
feet
Beaded strap
Installation
Parts included:
1.
Remove shipping brace and shipping plug.
2.
Wipe out inside of washtub.
3.
Connect ll hoses – water pressure = 20-120 psi [138-827 kPa].
• Two required, sold separately
• Flush water supply lines
• Use two lter screen washers with screen facing faucet
• Use two rubber washers in end of hose connecting
to the machine
4.
Connect drain hose to drain receptacle – 36 in. [91 cm]
recommended height.
• Use beaded strap to secure drain hose to drain receptacle
5.
Position and level washer – adjust front two legs. Tilt washer
forward and back to set rear legs.
• Place four rubber feet on leveling legs
6.
Connect washer to electrical power – on individual branch
circuit. Refer to serial plate for electrical ratings.
7.
Run washer through one complete cycle to make sure it is
operating properly.
Welcome
Thank you for purchasing a Speed Queen
®
appliance. We value you as a customer.
At Speed Queen, leading performance is our daily reality. We seek to deliver an outstanding
experience in every aspect of laundry. Your machine was built to last 25 years in your home and
Speed Queen support has been built to provide you with the best service in the industry.
8.
Check for leaks.