User Guide

© 2018 All Rights Reserved.
3
(SC-CB) Mini-Split Cassette Bib
®
Includes:
1. Plastic “Bib” (Part# CSB-011)
2. 5 Gallon Bucket (Part# BV-5-BUCKET-70M)
3. Plastic Hooks (Part# HWHK-6218)
4. Adjustable Cord (Part# MSB-06)
1
2
3
4
Prior to cleaning mini-split cassette
bib systems, please read all
manufacturer’s directions for
maintenance and apply any
cleaners per their specifically
supplied directions.
For Use with Optional Cassette Bib Stand:
1. Ensure that the stand with the attached bib will avoid any ceiling
obstructions.
2. Open the Dolly and place it on level ground.
3. Slide the Support Pole into the Pole Support that is located on the Dolly.
4. Screw the Hub onto the support pole.
5. Place the 4 frame rods into the slots on the outside corners of the
bib as shown.
WARNING: These rods are made of fiberglass and may cause splinters. Wear gloves when
handling these rods. When folding the dolly be careful not shear one’s fingers.
6. Place the 4 frame rods into the Hub.
7. Position the center of the Cassette Bib under the ceiling unit to
be cleaned.
8. Place the tube of the Cassette Bib into the 5 gallon bucket provided.
WARNING: If the water starts to puddle, manually open the drain tube. If too much water
starts to puddle, the balance will be off and the stand may tip over.
**CSB-DA Assembly Includes:
2x Cross Bar (Part# CSB-004)
1x Pole Support (Part# CSB-009)
2x Caster Riser (Part# HWN-37Fx2)
6x Caster Washer (Part# HWW-31)
1x ¼-20 Bolt, 3” (Part# HWS-2520-3SH-SS)
4x Caster (Part# 015-13)
2x Caster Bolt (Part# HWS-3775HH)
2x Caster Acorn Nut (Part# 015-15)
1x Thrust Bearing Washer (Part# HWW-2587-06)
1x Nylon Lock Nut (Part# HWN-251)
Use with These Products
CoilJet
®
from SpeedClean is a portable coil cleaning system. It
is battery operated and includes water, coil cleaner and more.
125 PSI, ½ GPM
Available Accessories:
24” Flexible Wand (Part# 8945-0-DEG-FLEX)
Mini-Split Cassette Bib
®
Kit
Mini-Split Cassette Bib
®
Kit