Product Manual
First use
Before rst use, remove all packaging materials including outer carton, PE
foam and gummed paper bag, etc., and tear o the protective lm on the
product, if any.
Keep the product away from heat sources and prevent it from being
exposed to direct sunlight. Do not place it in wet or watery places, so as to
prevent rust or degradation of insulation eect.
Place the product in an indoor well-ventilated place with flat and solid
ground
REAR
LEFT/RIGHT
FRONT
UP
＞ 15cm
Open space
Open space
Open space
Note: ＞ 15cm
Considerations for placement
Power supply connection and power-on
Be sure to place the product on the ground, with an open space reserved
above its top, a distance more than 15cm reserved between its back and
the wall, and no other obstructions on both sides of the product.
After the product is turned on with power supply connected for the first
time, rest it for 5-10 min to check the product for appearance defects or
unusual operating noise, and if any abnormality is found, turn o the power
supply, and contact the after-sales service personnel.
Except for rear side, reserve an open space in front, on left and right and
above the top of the product to facilitate the normal use and avoid injury.
After power-on, verify that the environment around the product meets the
use standard, and the footboard is at without tilting.
Place the product in a dry environment, and do not use it outdoors.
After the above inspections and conrmations can the product be used.
Use the power cord
to connect
the power supply
th
re
e
-pin soc
ket
Connect
the power supply
1
Press the power bu tton
Power-on
2