User`s guide

Programming function:

Remapping a button function to another button

Press Select. All LEDs will ash. Programming mode is now active.

Press the button whose function you want to remap to another button. Either

four LEDs for the pedals or two LEDs for the control paddles will now start

to ash.

Press the button which you want to remap the function to. All LEDs will ash

continuously. Repeat steps 2 and 3 for remaining buttons.

To exit programming mode, press Select again or wait six seconds, after

which the steering wheel will automatically exit programming mode.

PlayStation

The right and left control paddles are set to R2 and L2 as factory default. Pe

dals are set to gas and brake and have the same functions as the buttons X and

.

The control paddles and pedals can be remapped to the following buttons:

,

X, , , L1, L2, R1, R2, L3 (ß), R3 (à) and RY axis (áâ).

Some games use the right analogue stick for gas and brake as standard. To

transfer the pedal function to the right analogue stick press START + left direc

tional button + gas pedal, followed by START + left directional button + brake

pedal. This function is only supported in analogue mode. The setting is dele-

ted if the steering wheel is switched to digital mode or if the games console is

switched off.

The right and left control paddles are set to Keys 1 and 2 as factory default. The

pedals are set to Y axis up and down.

The control paddles and pedals can be remapped to the following keys: 1, 2, 3,

4, 5, 6, 7, 8, 11, 12, Y axis.

Resetting all changes made

Either press „Mode“ for three seconds, or unplug the steering wheel from the

games console, or turn the games console off.