Installation Manual

5 SpeedTech Lights, Inc © 2019
PA 100 AIR HORN
PUBLIC ADDRESS
All rights reserved. No part of this Instruction Manual may be reproduced, distributed, transmitted, or otherwise shared in any form or by any means, including but not limited to
photocopying, recording, electronic delivery, .PDF reproduction, or any other means of reproducing all or any part hereof without the express prior written consent of SpeedTech
Lights, Inc, except for non-commercial purposes as permitted by United States copyright law. Customers of SpeedTech Lights, Inc, may download and print this Instruction
Manual for use with products sold to the customer by SpeedTech Lights, Inc. However, no part of this Instruction Manual may be otherwise or subsequently reproduced,
downloaded, disseminated, published, or transferred, in any form or by any means, except with the prior written consent of SpeedTech Lights, Inc.
Connecting Microphone
1. Line up the 3 pins in the controller Mic port to the 3 holes in the microphone
connector.
2. Once the pins are inserted in the microphone connector, tighten the microphone
connector to the controller Mic port by rotating the shroud at the end of the
microphone connector clockwise until it is fully tightened.
Connecting A Speaker (Sold Separately)
1. Take one of the Brown cables and connect it to one of the Speaker cables. There
is no polarity on these connections, so it doesn’t matter which cable is chosen.
2. Take the other Brown cable and connect it to the other Speaker cable.