Installation Manual

ManualsBrandsSpeedTech Lights ManualsBuilding SuppliesCircle Carbine Floodlight Round 4 Off Road LED Work Light

CIRCLE CARBINE®

Wiring: Connecting Wires to the Battery

WARNING! If you are supplying your own wiring that connects to the positive or negative terminal of the battery, fuse sizes must be sized accord-

ing to STL’s provided fuse to be considered fused properly to the battery in order to carry the load.

• Route the power cables by opening the wiring shield and running the cables through it towards your vehicle’s rewall.

• Follow the factory wiring harness through the rewall.

• If it is necessary to drill a hole in the rewall for the power cables, be sure no components will be damaged from drilling. As with all holes

that are drilled, le the edges down smooth and insert a grommet to protect the cables.

• Route the cable along the factory wiring harness towards the battery.

• You will want to ensure your grounding cable is taken directly to the negative terminal of your battery to avoid any electrical feedback

which may disrupt your Light Bar system.

• DO NOT allow the positive (Red wire) and negative (Black wire) to touch one another. This may cause injury to you and damage your equip-

ment by causing a short in the unit that is not covered under the STL warranty.

Wiring: Connecting Extension Cables

• This unit will feature a power harness with two (2) colored leads.

• If you have an extension cable with connectors, connect the corresponding ends to one another.

• If you have an extension cable with no connectors, you will need to cut in the middle of the main cable harness coming out of the Light

Bar. You will solder, and heat shrink each wire within the cable harness to each wire in the extension cable harness. DO NOT cross connect

wires. DO NOT leave connectors, cables, solder points exposed to heat or moisture or debris.

Maintenance

While STL’s Light Bars are very durable, there are some things you need to keep in mind and practice to preserve the longevity and function of

your bar.

• Never take any STL Light Bars through a car wash, such as a pressure washer, automatic car wash, brushes that will scratch your equipment

or similar car washes or equipment where chemicals, high pressure water, and materials may scratch or damage your equipment.

• Use Water (H2O) with a soft cloth to clean your Light Bar and lenses.

• Yellowing of clear lenses may occur overtime. Lenses can be purchased by calling STL Customer Service at 800-757-2581.

All rights reserved. No part of this Operations Manual and Instructions may be reproduced, distributed, transmitted, or otherwise shared in any form or by any means, including but not limited to photocopying, re-

cording, electronic delivery, .pdf reproduction, or any other means of reproducing all or any part hereof without the express prior written consent of the SpeedTech Lights, Inc., except for non-commercial purposes as

permitted by United States copyright law. Customers of SpeedTech Lights, Inc., may download and print this Operations Manual and Instructions for use with products sold to the customer by SpeedTech Lights, Inc.

However, no part of the Operations Manual and Instructions may be otherwise or subsequently reproduced, downloaded, disseminated, published, or transferred, in any form or by any means, except with the prior

written consent of SpeedTech Lights, Inc.