May 22, 2014 ATS T56 Transmission Crossmember ’67-69 Camaro/ ’68-74 Nova Installation Instructions 1|Page
The following instructions are intended for professional installers and are guidelines only. Speedtech Performance assumes NO responsibility for the installation of any of its products. All products are intended for off road use only and must be installed by qualified professionals only. Thank you for purchasing your new ATS AFX spindle Kit. Installing this product will require the removal of some frame components and will require working on the bottom of your car.
1. Assemble the Stainless adjusters to the frame plates (2,5). Use Antiseize on all bolts. 2. With the old transmission crossmember removed and your T56 held in place with a tranny jack, install the right and left side frame mount plates (1,3) on top side of the frame rail. These frame mounts go on specific sides and are marked accordingly. If it is too tight to fit the brackets in place you may need new body mounts. Only hand tighten them at this time. 3.
. Once everything is lined up, tighten all crossmember mount bolts. Lower the transmission onto the pad and install and tighten the transmission mount bolts. Note: In the future, to lower the transmission you can simply remove the cross bar from the side mount plates.
Terms and Conditions of Sale 1. Effective January, 2008, supersedes all previous policy statements. Policies are subject to change without notice. Speed tech performance Ltd. is not responsible for printing errors. 2. Speed Tech Performance Ltd. does not endorse, nor recommend modification of vehicles for use on public highways, since warranty or government regulations may be violated.
Speedtech Performance USA LLC 3884 S River Rd, Bldg A St George, UT 84770 435-628-4300 speedtechperformance.
This page intentionally left blank 7|Page
This page intentionally left blank 8|Page
