User Manual

8 | P a g e
7. Reinstall the tie rod end into the steering arm and torque to 35 ft/lbs. Install
new cotter pin. Release tension from floor jack and move it out of the way.
Repeat process for the other side.
Note: The ATS spindle requires a C5/6 based brake package to be installed. We
recommend Baer or Wilwood brakes. Follow manufacturer's instructions for your
specific brake system. Be sure to properly bleed the brakes before driving the
vehicle.
8. Have a suspension alignment performed by a competent shop familiar with
performance type alignments. Page 9 lists recommended alignment specs. We
do not recommend using pre-programmed alignment shop factory specs.
Maintenance:
All aluminum has an endurance limit. Therefore, it is recommended to replace
spindles every 15 years or 225,000 miles as a precautionary measure.
Speedtech uses special jigs to install ZR1 hubs into our ATS spindles. Should
your hubs ever need servicing, it is recommended you ship the spindles to us so
that we can use the same process we used to originally build them. Servicing
them other than through Speedtech Performance will waive any implied or
expressed liability for the hub and/or spindle.