Warranty

4
• Risk of electric shock. This tool is not provided with an insulated gripping surface.
Contact with a “live” wire will also make exposed metal parts of the tool “live” and shock
the operator.
• Avoid body contact with grounded surfaces such as pipes, radiators, ranges, and
refrigerators. There is an increased risk of electric shock.
• Examine the work piece to avoid contact with hidden wiring. Thoroughly investigate the
work piece for possible hidden wiring before performing work. Contact with live wiring will
shock the operator.
• Use clamps or another practical way to secure and support the work piece to a stable
platform. Holding the work by hand or against the body is unstable and may lead to loss
of control.
• Do not force the tool. Use the correct tool for the job. The correct tool will do the job
better and safer at the rate for which the tool is designed.
• Do not use the tool if the switch does not operate. Any tool that cannot be controlled with
the switch is dangerous and must be repaired.
• Disconnect the tool from the air source before making any adjustments, changing
accessories, or storing the tool. Such preventive safety measures reduce the risk of
starting the tool unintentionally. Turn off and detach the air supply, safely discharge any
residual air pressure, and release the trigger before leaving the work area.
• Store the tool out of the reach of children and other untrained persons. This tool is
dangerous in the hands of untrained users.
• Maintain the tool with care. Keep a cutting tool sharp and clean. A properly maintained
tool, with sharp cutting edges reduces the risk of binding and is easier to control.
• Check for misalignment or binding of moving parts, and any other condition that affects
the tool’s operation. If damaged, have the tool serviced before using. Many accidents are
caused by poorly maintained tools. There is a risk of bursting if the tool is damaged.
• Use only accessories that are identified by the manufacturer for the specific tool’s
model. Use of an accessory not intended for use with the specific tool model, increases
the risk of injury to persons.
Important Operating Instructions
GENERAL SAFETY INSTRUCTIONS