Warranty

8
Important Operating Instructions
WARNING: Read the ENTIRE important operating instructions before set-up or use of this
product.
Inspect tool before use, looking for damaged, loose, and missing parts. If any problems are
found, do not use the tool until it has been repaired.
WARNING: To prevent serious injury from accidental operation, turn off the tool, detach
the air supply, safely discharge any residual air pressure in the tool, and release the trigger
before performing any inspection, maintenance, or cleaning procedures.
To prevent serious injury, do not adjust or tamper with any control or component in a way
not specifically explained within this manual. Improper adjustment can result in tool failure
or other serious hazards.
Installing & removing the sockets
1. To install the sockets:
a. Disconnect the tool from the air source
b. Select the suitable and desirable socket size. (not included)
c. Press fit the anvil into the socket.
2. To remove the socket
a. Disconnect the tool from the air source.
b. Use your hand or a suitable tool to carefully remove the socket.
TOOL SET-UP
1. Designate a work area that is clean and well-lit. The work area must not allow access by
children or pets to prevent distraction and injury.
2. Route the air hose along a safe route to reach the work area without creating a trip
hazard or exposing the air hose to possible damage. The air hose must be long enough to
reach the work area with enough extra length to allow free movement while working.
3. Secure a loose work piece using a vise or clamps (not included) to prevent movement
while working.
WORK AREA SET-UP