Spektrum DX3 SMART DSMR Transmitter Manual

Using An AVC
®
(Active Vehicle Control) Receiver With the DX3 Transmitter
If using an AVC receiver, such as the SR6100AT, follow bind and calibration instructions as indicated in the receiver manual. To
use the DX3’s CH3 functions with AVC activated, plug into the AUX3 port on the receiver. Use the CH3 A and B buttons as usual.
4 SPEKTRUM DX3 USER GUIDE
EN
SR315 RECEIVER
Specifi cations
Type: DSMR
®
(DSM2
®
compatible)
Dimensions (LxWxH): 32.5mm× 21.5mm × 13.4mm
Antenna Length: 3.5 in (90mm)
Channels: 3
Weight: 6g
Band: 2.4GHz (2404 MHz – 2476 MHz)
Voltage Range: 3.5–9.6V
Bind button
Antenna
Steering
Throttle
Aux 1
Battery Port
Standard Mode (default)
If loss of signal occurs, SmartSafe™ technology moves
the throttle channel to its designated failsafe position (low
throttle, neutral trigger) that was set during binding. All other
channels hold their last position. When the receiver detects
signal from the transmitter, normal operation resumes.
To bind in Standard Mode:
1
Center the throttle trim knob on the transmitter and
ensure the throttle trigger is at the neutral position.
2 Push and hold the receiver bind button.
3 Power on the reciever. The receiver LED will  ash rapidly.
4 Release the receiver bind button.
5 Push and hold the transmitter bind button.
6
Power on the transmitter. The transmitter power LED will
 ash and glow solid when binding is complete.
7 Release the transmitter bind button.
Preset (Gas) Mode
Preset failsafe is ideal for most nitro/gas vehicles. With preset
failsafe, all channels go to their preset failsafe positions
if the signal is lost, preventing an out of control situation.
When the receiver detects signal from the transmitter, normal
operation resumes.
To bind in Preset Mode:
1
Center the throttle trim knob on the transmitter and
ensure the throttle trigger is at the neutral position.
2 Push and hold the receiver bind button.
3
Power on the reciever. The receiver LED will  ash
rapidly. Keep the receiver bind button depressed until
the bind process is complete.
4 Push and hold the transmitter bind button.
5
Power on the transmitter. The transmitter power LED will
 ash and glow solid when binding is complete.
6 Power off the receiver.
7 Release the receiver bind button.
BINDING
Binding is the process of programming the receiver to recognize the GUID (Globally Unique Identifi er) code of a single
specifi c transmitter. The DX3
™
transmitter and SR315 receiver are bound at the factory. If you need to rebind, follow the
instructions below. You must rebind when:
• Different failsafe positions are desired e.g., when throttle or steering reversing has been changed.
• Binding the receiver to a different transmitter.
• Binding the transmitter to a different receiver.
Failsafe position is set during binding. In the unlikely event that the radio link is lost during use, the receiver will drive all
channels to its programmed failsafe position. The included SR315 receiver may be bound in either of two failsafe modes,
Standard Mode or Preset (Gas) Mode.
If using a SMART ESC and SMART battery, the transmitter SMART Battery Level indicator will show the vehicle battery level
within 10 seconds of powering on and binding.
Power
Bind