DX5 Pro 2021 Manual

13
SPEKTRUM DX5 PRO • TRANSMITTER INSTRUCTION MANUAL
EN
FUNCTION LIST
Mixing (continued)
The MOA Throttle Mix is used to adjust the throttle bias on rock
crawlers using a “motor on axle” conguration.
1. Select THROTTLE and click the scroll wheel.
2. Select MOA and click the scroll wheel.
3. To activate, select Inhibit and scroll to select THR > AUX.
4. Assign a switch to the mix.
Only the rate value for the front motor can be edited. As you
congure the front rate, the rear rate is updated appropriately to
show the distribution.
Motor on axle (Moa)
Programmable Mix
A freely assignable mix allows drivers to set up a second (Slave)
channel to follow a primary (Master) channel.
1. Select Mix O and click the scroll wheel. In the mixing menu,
select Mix O to rename the mix.
2. To activate, select a Master and Slave channel and assign
the Rate.
• Select Inhibit under Master and scroll to select the
Master (input) channel.
• Select Inhibit under Slave and scroll to select the Slave
(output) channel.
• Rate settings dene travel limits and direction. Move the
input channel (steering wheel, throttle, or whatever function
is assigned to the master channel) to adjust the rate for
each side of the slave channel travel. Setting this value
positive or negative determines the slave servo direction.
3. Select Switch; Inh will disable the mix,
ON will activate the mix, or a switch
can be assigned to turn the mix on
and off.
4. Set Trim to Act or Inh (Default). When
Trim is Active, adjustments to the
Master trim carries over to the Slave
channel.
AVC
®
Programming Menu
The DX5 Pro includes a menu for optional AVC receivers (not
included). This menu manages AUX 1 and AUX 2 operation and
tailors it for AVC technology use. When AVC is active, the radio
system will use the AUX 1 and AUX 2 channels for gain control.
AUX 1 will follow steering gain, and AUX 2 will follow throttle
gain. AUX 1 and AUX 2 are not available for use in mixes when
AVC is active. For an independent channel, use AUX 3.
When not using an AVC receiver, leave the AVC menu in the DX5
Pro inhibitied (INH)
To activate the AVC menu:
1. Select AVC in the main menu
2. Select Switch and use the scroll wheel to select On to
enable the AVC menu.
3. Change the gain and priority values to suit the vehicle.
4. To ne tune each value during use without having to
access the programming menu, assign a trimmer to the
On-The-Fly (OTF) feature for each AVC value. Click on the
arrow to the right of the switch selection to set the trimmer
to increase or decrease the gain from the set value.
TIP: Trimmers can only be assigned to one
OTF function; Steering and throttle gain
values cannot be adjusted from one trimmer
button.
IMPORTANT: If an AVC receiver is bound with a
single bind plug, and no bind plug in the disable
port, it will be in AVC mode.
If the AVC feature in the receiver is active and
the AVC menu in the transmitter is inhibited, AVC
functions will default to the AUX 1 and AUX 2
operation, and in this scenario, AVC will not work
correctly.
For AVC equipped recievers (not included with the
DX5 Pro), selecting INH in the AVC menu alone will not
disable AVC .