DX5 Pro 2021 Manual

22
SPEKTRUM DX5 PRO • TRANSMITTER INSTRUCTION MANUAL
EN
1. Select the CREATE NEW MODEL and click the scroll wheel.
2. Select CREATE to create a new model or CANCEL to go
back.
3. The new model is available in the model select list.
CAUTION: NEVER change the model
in Model Select while operating a
model. Changing the model memory
interrupts the transmitter signal to the
receiver and may cause loss of vehicle
control, damage or personal injury.
Use this selection to permanently delete a model from the model
select list. If you do not wish to delete a model, select Cancel to
exit the page.
1. To delete a model, highlight the model listed. Press to select
then roll to the model name. Click the scroll wheel to select.
2. Select DELETE to delete the model.
Use the Model Reset menu to delete all model programming in
the active model memory. Reset returns all model settings to the
default settings and erases all programming in the selected model.
IMPORTANT: After a model reset, it is
necessary to re-bind.
The Model Copy menu enables you to duplicate model
programming from one Model List location to another.
Use Model Copy to:
• Save a default model copy before experimenting with
programming values
• Expedite programming for a model using a similar
programming setup
IMPORTANT: Copying a model program from one model
memory to another will erase any programming in the “To” model
memory.
You cannot use the Model Copy screen to copy model
programming to an SD Card. To copy model programming to the
SD Card, please see “Transfer SD Card”.
To copy model programming:
1. Select where to save the copied
memory by selecting “TO” and scroll
to ADD NEW MODEL. Click the scroll
wheel once to save the selection. To
save over a current model select that
model from the list.
2. Select the model to be copied by
selecting “From” and scroll to the model
to be Copied.
3. Scroll down to COPY at the bottom of
the screen and click the scroll wheel once.
4. Conrm the copy by selecting COPY or CANCEL to go back.
SYSTEM SETUP
Create new model
Delete Model
Reset Model
Model Copy