SPMR8200-NX8 2.4GHz DSMX Manual

38 SPEKTRUM NX8 • TRANSMITTER INSTRUCTION MANUAL

Use System Setup to enter the System List from the Function list

without turning the transmitter off. A caution screen will appear

that warns that RF will be disabled (the transmitter will no longer

transmit). Press YES if you are sure and want to access the System

List. If you are not sure, press NO to exit to the main screen and

continue operation.

If you do not press YES or NO, the system will exit to the main

screen and continue operation within approximately 10 seconds.

WARNING: Do not press YES unless the model is turned

off or the model is secured.

System Setup

The Monitor screen displays the servo positions for each channel

graphically and numerically. This is useful to verify programming

functions, trim settings, mix directions, etc. The numeric value

is directly relative to the travel adjust and mix values (e.g. 100%

travel adjust equals 100% value in the Monitor).

Monitor

The Start Trainer menu allows you to put the transmitter in either

instructor or student mode, from the Function List.

Start Trainer

Bind

The Bind menu allows access to the bind screen from the Function

List. After selecting Bind, a caution screen appears warning the

transmitter RF will be disabled. Press YES to continue to the bind

screen or NO to return to the Function List.

The Bind menu enables you to bind a transmitter and receiver

without powering off the transmitter. This menu is helpful if you are

programming a model and need to bind the receiver for failsafe

positions.

See “Programming Failsafe Positions” for more information.