Spektrum FC6250HX Manual

Binding

1. Power ON the FC6250HX  ight controller and press the bind button on each

remote. The remote will begin  ashing, indicating it is ready to bind.

2. Press the bind button on your transmitter. Lower the throttle stick to the stop

position and power ON the transmitter.

Once the bind process is complete, the remote receiver LED turns solid

orange, indicating the FC6250HX is ready for setup.

The FC6250HX LED will begin  ashing green, indicating a successful bind.

A red  ashing LED indicates binding is not successful. Begin the binding

procedure again.

Setup

1. In your transmitter, create a new heli setup as a Normal swash plate type.

Set the Frame Rate to 11ms.

The FC6250HX requires the default new model transmitter con guration.

All channels, other than throttle, must have Reversing set to Normal.

All channels, other than throttle, must have the Subtrim set to 0.

All channels, other than throttle, must have the Travel set to 100/100.

All throttle channel settings occur in the following setup procedures within

the transmitter. If you are using a throttle servo do not connect the servo

until you reach the throttle setup step below.

Con gure your desired  ight modes, throttle curves and pitch curves per

the respective manufacturer recommendations for the helicopter, ESC

Engine and Transmitter. Please take note that the collective pitch range will

be setup within the FC6250HX setup instructions below.

Within your transmitter enable the Transmitter Gyro function and select

the“Flight Mode Switch” option. Set each  ight mode gain to 75%.

2. In the transmitter menu, select Forward Programming.

The transmitter connects to the  ight controller, and a menu list displays.

3. Navigate to the SetuptSwashplatetOutput Setup menu again.

4. Set the Frame Rate to the operating frequency speci ed by your servo

manufacturer.

5. Select the Type menu. Set the swashplate type to match your helicopter’s

con guration. Connect the servos shown on the transmitter and per the

Flight Controller connection diagram.

Select Back, and navigate to the Direction menu.

6. Set the servo reversing to ensure the collective pitch stick moves the

servos in the direction of positive collective.

Select Back to return to the previous menu.