Spektrum FC6250HX Manual

EN
8
16. Exit Forward Programming. Con gure the throttle settings according
to the instructions provided by your ESC/Internal Combustion Engine and
Transmitter manufacturer.
17. Once throttle setup is complete, enter Forward Programming mode, and
select the SetuptThrottletFailsafe menu.
18. Lower the throttle stick to the full stop position, and select Capture to
record the throttle fail safe position.
Select Back to return to the SetuptThrottle menu.
19. Select ThrottletHover
This setting is the throttle point where your model hovers in normal mode,
mainly during takeoff and landing. The  ight controller applies special
anti roll over algorithms at or below the throttle setting, helping to make
takeoffs and landings easier. The Stunt 1 and Stunt 2 throttle curves
should be above the hover throttle setting to ensure the roll over mitigation
is disabled in  ight.
During the initial setup, you can set ThrottletHover to a high value
and test the model. Once the throttle setting is determined for hovering in
normal mode, set the Hover Throttle value.
Select Back to return to the Setup menu.
20. Select the Gyro SettingstOrientation Menu, and set the mounting ori-
entation to match the FC6250HX mounting orientation on your helicopter.
Once complete, physically move the helicopter on each axis to ensure the
gyros are compensating in the correct direction.
Select Back twice to return to the Setup menu.
21. Select the FM Channel and select Inhibit. After initial test  ights, if you
would like to use individual gains per  ight mode, set the FM Channel
within the Setup menu.
22. The Gain Channel defaults to the gear channel. This is the transmit-
ter aux gyro gain channel for the tail rotor. Enable the Gyro function on
transmitter and set the gain to 75% for all  ight modes.
23. Press Back to exit the forward programming menu, and save the param-
eters.
The FC6250HX  ight controller setup is complete.